How to build muscle?

Nowadays, people are eager to have a good figure, which can make their image and temperament better. However, in addition to the curvy figure that girls yearn for, the muscular beauty has also been the pursuit and goal of many people. However, it is much more difficult to build muscle. After all, the amount of exercise required is still very high. So how can you build muscle?

1. The main methods of reaching muscles

The main method to develop muscles is the barbell bench press, and other exercises are auxiliary. Because the size of the muscles trained is directly proportional to the weight lifted. The weight of the bench press barbell is relatively much larger than that of the dumbbells. It is very difficult to do bench presses or flyes with heavy dumbbells. Under normal circumstances, if the weight of the bench press reaches 60 kg and 8 to 10 times are done in each set, the chest circumference can be trained to 95 cm. If you use 100 kg for training, your chest circumference will exceed 100 cm and reach 120 cm.

2. Design and Practice of the Bench Press Barbell

When doing barbell and dumbbell exercises, the muscles being trained are mainly affected by factors such as the weight of the bar, the way of holding the bar, the grip distance, the lifting angle, the lifting speed and the number of sets. The bar diameter of the bench press barbell should be slightly thicker, with an outer diameter of 35-40 mm and a wall thickness of 2.5-3.0 mm. A thicker lever can reduce the unit pressure on the palm, increase the force-bearing area, and facilitate pushing the arm up. The distance from the grip to the bell plate should be short, about 100 mm, so that the weight (force) is concentrated on the vertical plane close to the pectoral muscles and the generation of force couple can be reduced.

The lever must be raised and lowered in the area of ​​the chest muscles being trained (from the diaphragm down to the clavicle up). The chest should be trained from bottom to top and from wide to narrow, that is, first train the lower chest (lying on the side), then train the middle chest (lying flat), and finally train the upper chest (lying on the side). First, use a wide grip, then a medium grip, and finally a narrow grip. Using a wide grip bar will train the width of your chest muscles, while using a narrow grip bar will train the height (thickness) of your chest muscles.

As for the bench press, a short bench is used for the incline bench press (20-30 degrees) and the flat bench press. When pressing, only the upper back touches the bench surface, which can make the chest stand up and increase the unit pressure. Using a seated curved bench (30-45 degrees) for the incline bench press can lift the upper chest and make it horizontal, allowing the barbell to act vertically on the upper chest muscles.

Through the above introduction, everyone has a clear idea of ​​how to build muscles. Muscle training methods can be selected according to everyone's preferences, but it is best to diversify the exercise methods and perform them regularly over a long period of time. On the one hand, it can avoid muscle fatigue, and on the other hand, it can make muscle training more effective.